This package is a complete solution that allows fast development and configuration of interlocks, a task that normally takes a lot of time. This works with 32 inputs and comes with four faceplate's sizes suitable for all types of HMI and SCADA systems.

The module provides control of a pump (or motor).

Module for control of two-position actuator with feedback

The module provides motor control with thermal overload and HMI Faceplate.

The module processes the 2 analog inputs and provides one analog output.

The Add On Instruction is used for the control of an Industrial Safety Gate (Euchner MGB series).

AOI for 2 in 1 Out Linear Cylinder Control and fault report.

AOI for 1 in 2 out Linear Cylinder Control and fault report.

AOI for 2 in 2 out Linear Cylinder Control and fault report.

This module copies the state of the inputs to the outputs when enabled. Default state is off.

Flow Rate Conversion (Mass)

Flow Rate Conversion (Volume)

Temperature Conversion

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

Used for latch an output OFF when the corresponding input to the module goes OFF.

Used for latch an output ON when the corresponding input to the module goes ON.

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

The BNOT16 block allows up to 16 Boolean conditions to be inverted. By using the BNOT16 block in application code the required inversion of signals is clearly shown within the Function Block Diagram (FBD).