Module for control of two-position actuator with feedback

Elapse/Remaining Timers accumulated values conversion in clock format .

Temperature Conversion

The module provides control of a pump (or motor).

The module provides motor control with thermal overload and HMI Faceplate.

This block limits an input depending on the configured high and low values and transfer the value to the output depending on the limits.

Used for latch an output ON when the corresponding input to the module goes ON.

Used for latch an output OFF when the corresponding input to the module goes OFF.

This package is a complete solution that allows fast development and configuration of interlocks, a task that normally takes a lot of time. This works with 32 inputs and comes with four faceplate's sizes suitable for all types of HMI and SCADA systems.

The Add On Instruction is used for the control of an Industrial Safety Gate (Euchner MGB series).

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

This module copies the state of the inputs to the outputs when enabled. Default state is off.

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

Flow Rate Conversion (Volume)

Flow Rate Conversion (Mass)

AOI for 2 in 2 out Linear Cylinder Control and fault report.

AOI for 2 in 1 Out Linear Cylinder Control and fault report.

AOI for 1 in 2 out Linear Cylinder Control and fault report.