The Analog Output AOI Control Module is used to condition an engineering unit analog output value into the proper range for analog output modules and devices. Note: Programmed followed ISA88, ISA95 and ISA106 Standard

This piece of code is provided as a ladder coded Routine.

Converts Milliseconds to Hours / Min / Seconds.

User-defined function block for CCW aimed at controlling hydraulic systems comprising of a single general proportional control valve and up to 4 bidirectional 4/3 on/off valves.

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

SCALE_AI Add on instruction converts raw value from Analog Input channel to engineering value and in addition presents several alarms based on user configuration, including Hi, HiHi, Lo and LoLo Alarms.

Works exactly like a for do loop in higher programming language but used in ladder logic

This module is for Mitsubishi Fx3U and is built on GX works tools in function block diagram This totalizer will totalize the flow rate. The totalizer will auto reset at user's defined value as well user controlled reset is also given.

Determines if a value stays within a % range for an amount of time and returns TRUE when it does. Useful for applications in weighting quantities