Ramp block that generates a ramp using acceleration and deceleration values defined by user.

Determines if a value stays within a % range for an amount of time and returns TRUE when it does. Useful for applications in weighting quantities

This block limits an input depending on the configured high and low values and transfer the value to the output depending on the limits.

Takes the input from the analog card.Outputs a scaled value and HH/HI/LO/LL alarms. Can be imported as a library and it will create all the variables automatically or can be imported as a AOI.

A variable input that you want a non-linear varied output.

Integer Value Move to BIT status (Version Studio5000 V32.02)

The instruction uses to toggle the signal

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.