Analog Raw Value from Sensors Scaling to real Value

The AOI provides a sensor signal to be treated according to its authenticity proof. The AOI is mainly developed to be used with any industrial protocol sensor/gateway/module (ex. Modbus sensor/gateway, remote IO etc), but could be used with any analog measured value.

Count the operating time of equipment

Double Solenoid 2 position operation

This module is for Mitsubishi Fx3U and is built on GX works tools in function block diagram This totalizer will totalize the flow rate. The totalizer will auto reset at user's defined value as well user controlled reset is also given.

Takes the input from the analog card. Outputs a scaled value and HH/HI/LO/LL alarms. Maintenance override switch functionality.

Contains a typical for digital Fail Close Valves with 1 solenoid and 2 limit switches. The valve closes if it is tripped or a command to close is set on it. Can receive manual operations like opening and closing the valve from a button(on the HMI).

The Digital Input AOI Control Module is used for general-purpose discrete inputs. Note: Programmed followed ISA88, ISA95, and ISA106 Standard

Module for control motor in 2 directions