All Products

View all the products
Global object, faceplate and AOI
INTERLOCK_32x1

This package is a complete solution that allows fast development and configuration of interlocks, a task that normally takes a lot of time. This works with 32 inputs and comes with four faceplate's sizes suitable for all types of HMI and SCADA systems.

25.00 (CAD)
Picture of Integrator
Integrator

This function integrates anything you may need. Just set the parameters and you will have the output ready to use.

35.00 (CAD)
INT_TO_BIT
Integer to Bit

Integer Value Move to BIT status (Version Studio5000 V32.02)

10.00 (CAD)
Picture of Input Bypass
Input Bypass

The module provides an alarm bypass function for Analog and discrete inputs.

25.00 (CAD)
Picture of Industrial Safety Door
Industrial Safety Door

The Add On Instruction is used for the control of an Industrial Safety Gate (Euchner MGB series).

25.00 (CAD)
IC_MOV_2P
IC_MOV_2P

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

10.00 (CAD)
Picture of High Level Alarm
High Level Alarm

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

10.00 (CAD)
Picture of Global Timer RTO
Global Timer RTO

This module converts a timer value (DINT) to a string value for display on an HMI.

25.00 (CAD)
Picture of Gate16ON
Gate16ON

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

25.00 (CAD)
Picture of Gate16Off
Gate16Off

This module copies the state of the inputs to the outputs when enabled. Default state is off.

25.00 (CAD)
Picture of Gage RR
Gage RR

The module stores a set of values (e.g. measurement) and provides their maximum, minimum and average values .

25.00 (CAD)
Picture of Function Norm
Function Norm

This module converts an analog value to its exponent (i.e exp + mantissa).

25.00 (CAD)
Picture of For_Do_Loop_AOI
For_Do_Loop_AOI

Works exactly like a for do loop in higher programming language but used in ladder logic

30.00 (CAD)
One
FO16On

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

25.00 (CAD)
Picture of FlowConvVolume
FlowConvVolume

Flow Rate Conversion (Volume)

25.00 (CAD)
Picture of FlowConvMass
FlowConvMass

Flow Rate Conversion (Mass)

25.00 (CAD)
fbd
Flashing On Off output

Use this control module to control output as on/off flashing output. An example may be 1s on, 2s Off flashlight. it also can be used for flashing a bit in HMI with set time durations.

5.00 (CAD)
Picture of Flasher Bit
Flasher Bit

Flashes an output based on user specified time values.

25.00 (CAD)
Picture of First Out
First Out

This module monitors the status of 16 discrete inputs and sets the Alarm Channel No to the value of the input channel that first goes into alarm.

25.00 (CAD)
Picture of First In
First In

This module captures the first channel that goes into alarm.

25.00 (CAD)
Picture of FCV Alarm
FCV Alarm

This module monitors the state of the FCV and provides alarms based on the status read by the open and close limit switches.

25.00 (CAD)