All Products

View all the products
Picture of RandomNo_AOI
RandomNo_AOI

This module generates a random number (data type: Real) between 0 and 1.

2.00 (CAD)
Picture of EDG_HMS v1.2
EDG_HMS v1.2

Converts Milliseconds to Hours / Min / Seconds.

2.00 (CAD)
Picture of Machine_run_time
Machine_run_time

This piece of code is provided as a ladder coded Routine.

3.00 (CAD)
Picture of Scantime
Scantime

Scantime function that can return scantime cycle in microseconds, milliseconds and/or seconds.

5.00 (CAD)
fbd
Flashing On Off output

Use this control module to control output as on/off flashing output. An example may be 1s on, 2s Off flashlight. it also can be used for flashing a bit in HMI with set time durations.

5.00 (CAD)
FBD call
DI1_OK_ALARM

When your Digital input has an OK state and Alarm state, you need to process it before you shall use it. For example, Safety System, Lift Door, Emergency Switch, an application where input states false or low shall give an alarm.

5.00 (CAD)
Picture of TON_Clock
TON_Clock

Elapse/Remaining Timers accumulated values conversion in clock format .

5.00 (CAD)
Picture of Analyze_Real8_AOI
Analyze_Real8_AOI

8 input REAL value, find minimum. maximun and average. Except 0 if input value = 0, it won't be counted in sum and average

5.00 (CAD)
Picture of SCALE_AI
SCALE_AI

SCALE_AI Add on instruction converts raw value from Analog Input channel to engineering value and in addition presents several alarms based on user configuration, including Hi, HiHi, Lo and LoLo Alarms.

5.00 (CAD)
Picture of CountOH
CountOH

Counting operating hour

10.00 (CAD)
Picture of High Level Alarm
High Level Alarm

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

10.00 (CAD)
Picture of Low Level Alarm
Low Level Alarm

This module sets an alarm when the measured value falls below the Low Level setpoint for longer than the Time value.

10.00 (CAD)
Picture of Bit to Integer
Bit to Integer

The module populates the status of bits into a integer.

10.00 (CAD)
Picture of SignalToogle
SignalToogle

The instruction uses to toggle the signal

10.00 (CAD)
INT_TO_BIT
Integer to Bit

Integer Value Move to BIT status (Version Studio5000 V32.02)

10.00 (CAD)
IC_MOV_2P
IC_MOV_2P

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

10.00 (CAD)