The module scales the raw input to the Engineering Range and creates High High, High, Low and Low Low alarms.

This module captures the first channel that goes into alarm.

This module sets an alarm when the measured value falls below the Low Level setpoint for longer than the Time value.

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

The program is designed to govern any sequential order of tasks done by outputs with basic feedback from inputs.

Analog Raw Value from Sensors Scaling to real Value

Counting operating hour

AOI for 2 in 1 Out Linear Cylinder Control and fault report.

AOI for 1 in 2 out Linear Cylinder Control and fault report.

AOI for 2 in 2 out Linear Cylinder Control and fault report.

This module copies the state of the inputs to the outputs when enabled. Default state is off.

The module selects the high, low or average value of 5 analog inputs.