3. Gate16ON
Picture of Gate16ON Picture of Gate16ON Picture of Gate16ON Picture of Gate16ON
Picture of Gate16ON
Picture of Gate16ON
Picture of Gate16ON
Picture of Gate16ON
Picture of Gate16ON
Bill Wallace

Gate16ON

Be the first to review this module

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

25.00 (CAD)

Add to cart

The Gate16On module is used to only allow the boolean conditions to be active when enabled. If not enabled all the outputs of the block are set to zero. This block is can be used with the interlock (P_Intlk) and Permissive (P_Perm) to enable process conditions that are only required under certain modes that the plant is operating under. Therefore, conditions that are not relevant under a certain plant mode of operation are disabled when that mode is selected.

PLC Code written in RSLogix 20.04

Customers who bought this item also bought

Picture of Latch16Off
Latch16Off

Used for latch an output OFF when the corresponding input to the module goes OFF.

25.00 (CAD)
BNot16 function block
BNOT16

The BNOT16 block allows up to 16 Boolean conditions to be inverted. By using the BNOT16 block in application code the required inversion of signals is clearly shown within the Function Block Diagram (FBD).

25.00 (CAD)
One
FO16On

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

25.00 (CAD)
Picture of Latch16On
Latch16On

Used for latch an output ON when the corresponding input to the module goes ON.

25.00 (CAD)