This module converts an analog value to its exponent (i.e exp + mantissa).

The module stores a set of values (e.g. measurement) and provides their maximum, minimum and average values .

This module copies the state of the inputs to the outputs when enabled. Default state is off.

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

This module converts a timer value (DINT) to a string value for display on an HMI.

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

The Add On Instruction is used for the control of an Industrial Safety Gate (Euchner MGB series).

The module provides an alarm bypass function for Analog and discrete inputs.

Integer Value Move to BIT status (Version Studio5000 V32.02)

This function integrates anything you may need. Just set the parameters and you will have the output ready to use.

This package is a complete solution that allows fast development and configuration of interlocks, a task that normally takes a lot of time. This works with 32 inputs and comes with four faceplate's sizes suitable for all types of HMI and SCADA systems.